Installation manual
IRIS Touch 400 Range Dialler Installation Manual V1.4
5
2. Before you start…
2.1. Package contents
In this package you should have the following components:
Main dialler PCB with four self-adhesive feet
Power cable (black) for connection to DC supply.
Ethernet cable (cream) for connection to IP network. (Ethernet / Ethernet &
GPRS only.)
Antenna for GSM/GPRS. (GSM / Ethernet & GPRS only.)
Dialler cable (grey) for connection to dialler output of alarm panel.
Sense resistor (18K ohm) for alarm dialler cable fault/tamper detection.
Installation manual.
2.2. Pre-requisites
For installations using IP (Ethernet) or GPRS you must ensure you have the
following:
If the installation is in a residential environment, you will need to fit
inductors to the input cables of the dialler in order to ensure compliance
with EMC Class B emissions requirements. Suitable inductors can be
obtained from Chiron.
The IP address for the monitoring centre.
Confirmation that the monitoring centre is set up and ready for the account
number or name to be used for this IRIS dialler.
The type of IP address (either automatic or fixed) for the installation site. If
the site has a fixed IP address, you should get this information from the
customer in advance, together with the Gateway Address and the Subnet
Mask for the IRIS dialler.
An additional long Ethernet CAT5 cable, in case the installation site
requires one longer than that supplied with the IRIS dialler. Cable lengths
up to 100m are allowable.
A SIM card enabled for GPRS with the PIN code clear. (Ethernet & GPRS
only.)
The GPRS Access Point Name (APN) of the SIM card provider. Some
networks also require a User Name and Password which can also be
obtained from the SIM card provider. (Ethernet & GPRS only.)