SINGLE DOOR FULL FREEZER USER MANUAL MODEL CSF080DW Customer Service 1300 796 688 www.chiq.com.
PART NAMES AND LOCATIONS 1 Top cover 2 Display Block 3 Freezer Flap 4 Middle Drawer 5 Low Drawer 6 Adjustable feet IN ACCESSORY BAG: USER MANUAL, WARRANTY CARD As the manufacturer holds the authority to redesign or modify its products without notice: Any modifications or upgrades of our products will result in this Freezer varying slightly from this manual but the functionality will remain the same to that as set out within this manual.
IMPORTANT SAFETY INSTRUCTIONS WARNING Follow these basic precautions to reduce the risk of fire, electrical shock hazards or injury when operating the Freezer: • This product has been designed for using in a normal domestic environment. It is not intended for commercial use which will avoid warranty, such as supermarket, food shop, pharmacy, commercial kitchen & etc.
R600a WARNINGS NOTE: This model uses R600a flammable refrigerant in its sealed system. The following must be observed for your safety: R600a Refrigerant Warning • This appliance contains 0.046KG R600a refrigerant which is environmentally friendly, but flammable. It does not damage the ozone layer, nor does it increase the greenhouse effect. • During transportation and installation, ensure that the tubing of the refrigerant circuit is not damaged. • Leaking refrigerant can ignite and may damage the eyes.
INSTALLATION INSTRUCTIONS Before Using the Freezer • • • Remove the exterior and interior packing. Before connecting the Freezer to a power source, let the unit stand upright for approximately 4 hours to mitigate the possibility of a malfunction in the cooling system from improper handling during transportation. Clean the interior surface with warm water using a soft cloth.
OPERATING INSTRUCTIONS Temperature setting The temperature of the appliance can be adjusted by turning the thermostat dial. The thermostat dial setting can be changed between 1 and 4. Please turn and get the small triangle sign to point the setting. 1 is the warmest setting. 4 is the coldest setting. The recommended setting is 2. Please note the appliance is using sensitive thermostat, it will keep more stable temperature inside the unit.
GENERAL CARE AND MAINTENANCE Cleaning the Freezer • Upon installation of your new appliance, it is recommended that it be cleaned thoroughly and properly maintained thereafter. • Turn off the Freezer and then unplug the unit from the wall outlet. • Remove all food content before washing the inside with a damp cloth soaked in lukewarm water and dishwasher liquid. Don’t use any chemical detergent which might damage coating or inner liner of the freezer.
TROUBLESHOOTING GUIDE Problem Solution Power cord isn’t plugged in properly. The circuit breaker tripped or a blown fuse. Try a different power point. The room temperature is hotter than normal. A large amount of food has been added to the Freezer. The door is opened too often. The door is not closed completely. The temperature control is not set correctly. The door gasket does not seal properly. The Freezer does not have the correct clearances.
The doors will not close properly. The Freezer is not on a level surface. The gasket/s may be dirty or not properly maintained. Clean the seals and make sure they are dry before closing the door/s. The storage basket and/or shelves are out of position.
Customer Service 1300 796 688 www.chiq.com.au c Changhong Electric (Australia) P/L all rights reserved.
