Specifications

Edition 3.0E, 2011/05
Modes of operation
There are 3 different modes of operation.
1. Normal mode: In this mode, the inverter works normally. Whenever the
supplied power from PV panel is sufficient (voltage>150VDC), inverter
converts power to the grid as generated by the PV panel. If the power is
insufficient (voltage<120VDC), inverter enters a “waiting” state. Whilst
“waiting” inverter uses just enough power from the PV panel monitor
internal system status. In normal mode the green LED is on.
2. Fault mode: The internal intelligent controller can continuously monitor
and adjust the system status. If inverter finds any unexpected
conditions such as grid problems or internal fail ure, it will display the
information on its LCD and light up the red “Fault” LED.
Initialization
Pr
ess
butto
n
(
1
sec)
Pr
ess
butto
n
(
1
sec)
Pr
ess
bu
tt
o
n
(
1
sec)
Pr
ess
butto
n
(
1
sec)
Pr
ess
butto
n
(
1
sec)
Pr
ess
butto
n
(
1
sec)
INIT OK
Press button (5sec) to set
intended Regulation type
“INIT OK” indicate
Regulation type setting is completed
VDE0126-1-1
RD1663
ENEL Guide 2010
CGC
G83/1-1
Only appear on
relevant model
Only appear on
relevant model