User's Manual

EN
1
SAFETY INSTRUCTIONS
Read the operating instructions carefully before use.
Save these instructions for future reference.
· Protect the appliance and the power cord from heat, sunlight, water and sharp
edges.
· Never poke any metal objects into the appliance – risk of short circuiting.
· Do not use the appliance in extremely dry air – risk of static electricity.
·
· The product may become warm when charging
· Do not modify the product – the manufacturer cannot accept liability for any
· The product and antenna must not be located or used in conjunction other
antennas or transmitters.
· Do not attempt to repair the appliance. Any repairs must be carried out by an
TECHNICAL DATA
Electrical data 14 VDC, 1 A
Bluetooth that supports 3.0+EDR
Range 10 m
Frequency response 80 Hz to 16 kHz
RMS-output 25 W (THD = 10%)
Distortion ≤ 0.5 %
Signal/noise ratio ≥ 65 dB
Drive unit 2 x 3"
Output power 2x12,5 W RMS
Battery capacity 2000 mAh
Operating time 3-4 hours
Charging time 2-2.5 hours
Interface BT, AUX
Dimensions 260 x 150 x 150 mm
Weight 2 kg
EN
2
DESCRIPTION
1 Bluetooth/AUX input selector 5 Previous song
2 Volume setting 6 Next song
3 Play/Pause 7 AUX input
4 Power switch 8 Charger socket (rear)
1 32
5 6
4 7
8
EN
3
USE
When the product is new
Charging the speaker
1. Connect the adapter cable to the speaker's charging port.
2. The red status light comes on to show that the product is charging.
3.
Pairing
1. Place the speaker within 9 metres of the Bluetooth device.
2.
3. Follow the instructions on the Bluetooth device to search for the speaker.
4. The speaker's name when pairing is M1. If a PIN code is requested, enter 0000.
5.
Use
Set the switch in the ON position to start the speaker. An audio signal is give and the blue status lamp
Status lights
Charging Red light on
Fully charged Red light out
Pairing mode
Connected Blue light on
Playback