salesinfo@chimeralighting.com www.chimeralighting.com 1812 Valtec Lane Boulder, Colorado 80301 Phone: (303) 444-8000 Fax: (303) 444-8303 Toll Free: (888) 444-1812 Outline - F2X Assembly Instructions Basic Information Layout the parts, grouping by color codes. Poles are bundled in specific groups for your convenience. Align tubes carefully as to not cross thread. Laying on the floor or a flat surface is helpful. Do not force if you encounter undue resistance.
Start Position all the bottom perimeter tubes first. Cross Brace Assembly (10x20’ and 10x30’ only) Layout a corner with a bottom long side tube, an assembled bottom end cross tube, one upright and an end cap. As you assemble, the threaded studs will all be pointing in the same direction. Repeat this for the opposite side. Next, assemble the bottom tubes of the next bay, with the upright tubes between the bays. Now go back and finish the top tube sections of the first bay.
Lightbank Cover CAUTION: take extreme care in next step to not get front diffuser dirty by dragging on the floor or ground. You can put clean material down over a dirty surface - tape it securely so it doesn’t move. Raise your F2X frame off the ground at this stage, but not too high, approximately 2 feet, either on short light stands or apple boxes, etc. Spread the cover and attach the four corner straps. Then lift and attach the end panels.
