ChilliP-A5-Manual-2020-Download

4. Instructions for use
4.a Diagram of the Outside of the Stove
Grate: the cast iron grill that sits on the base of the fire chamber (not shown in diagram).
Fuel retaining bar: this bar prevents logs falling against the glass and reduces ash fallout
onto your hearth.
Stove levelling bolts: bolts on each leg used to level the stove during installation
Primary air control knob: stainless steel knob on the LH side of the stove as you face it.
It controls the flow of air underneath the fire.
Secondary air control knob: stainless steel knob on the RH side of the stove as you face
it (fully out it will protrude 10mm further than the other knob). It controls the flow of air
over the top of the fire and the door glass.
Boost disc: brushed stainless steel disc with penguin logo on it. In the balanced open
position this will allow the maximum air flow in to the fire. It should swing easily into the
closed position once the fire is established.
Hinge pin: pins to hold the door to the stove body
Flue collar: the 5”/125mm collar on the top of the stove. The stove is designed to burn
on a 6” flue. A 5-6” adaptor is required unless the smoke control kit is fitted.
Stove Components
Flue collar
Hinge pin
Boost disc
Secondary
control knob
Primary
control knob
Stove levelling bolts x 4
Fuel retaining bar
30