ChilliP-A5-Eco-Manual-2020-Download

Thetemperatureatthebaseofastovewillaectthetypeofhearthrequired,see
“hearthrequirements”.Ifaconstructionalhearthisrequiredbutisnotpossible,
thenabaseheatshieldcanbettedunderneaththestove.Thisreducesthehearth
temperaturesandallow,thestovestobeinstalledontoasuperimposed(12mm)hearth.
Recordonthestoveinstallationpagewhetherabaseheatshieldhasbeentted.
3.h Base Heat Shield
To fit:Slideinatthebaseofthestovepriorto
installation.Itneedstoslideinfromtherear.
Theedgewiththecut-outshouldslideinrst,
restingatthefrontofthestove.Thefolded
legsoftheheatshieldwillsitonthetabsfor
thelevelingscrews,(thesearesmallsquare
tabswithaholeinthecentre).
Page 26 of 60
Diagramillustratingtheminimumdistancestononcombustiblesurfacesi.estone/brick
3.g Clearance to Non Combustible Walls
100mm
50mm
100mm
50mm
Model Rear
NB.Fluepipesafedistancescanbegreaterthantheappliance,dependingontype
MINIMUMDISTANCESTONONCOMBUSTIBLEWALLS
AllModels 50mm
Sides
100mm
Rearwallthicknessneedstobeatleast200mmthick.
Theseareminimumdistances.
Above
150mm