Instructions / Assembly
Table Of Contents
- 1. FOR YOUR SAFETY
- 2. LOCATION REQUIREMENTS
- 3. INSTALLATION PROCEDURES
- 4. PRESSURE LIMITER (optional)
- 5. CLEANING & SANITIZING
- 6. STORAGE
- 7. QUICK CONNECTOR FITTINGS
- 8. PRIMARY COMPONENTS DIAGRAM
- 9. ADJUSTING THERMOSTAT
- 10. SPECIFICATIONS
- 11. TROUBLESHOOTING GUIDE
- 12. WARRANTY & SERVICE
- An optional use 30 -50 psi (factory preset to 40 PSI) pressure limiter is available for the Chiller for use in certain applications. The pressure limiter is not needed if Chiller Daddy® is installed on a typical residential reverse osmosis RO syste...
5
Step 4. Removing the Tube or Plug
• Make sure to completely eliminate all pressure before removing
the tube from the Quick Connector Union fitting.
• Turn off the incoming feed water and open the faucet.
• When removing the tube or plugs, push and hold the collet clip
in against the fitting as you pull the tube or plug out. This
releases the tube or plug.
• Fittings and tubes can be reused. Be sure to check for possible
scratches on the tube when reusing.
8. PRIMARY COMPONENTS DIAGRAM
9. ADJUSTING THERMOSTAT
CAUTION: THE THERMOSTAT IS LOCATED INSIDE OF THE
CHILLER AND THE TOP MUST BE REMOVED TO MAKE AN
ADJUSTMENT. ADUSTMENT SHOULD ONLY BE DONE BY A
LICENSED REFRIGERATION TECHNICIAN. SETTING TOO COLD CAN
CAUSE THE UNIT TO FREEZE CAUSING PERMANENT FAILURE. The thermostat is
factory preset and requires no adjustment other than for abnormal
requirements. If needed, the water temperature can be adjusted by turning the screw on the cold