User Manual

Modules
Intel Turbo Memory Module 7 - 37
7
Intel Turbo Memory Module
If you have included an Intel Turbo Memory (Robson) NAND flash memory card
module
in your purchase option, th en you will need to enable the option in the BIOS
(see “Adv anced Menu ” on pa ge 5 - 8) BEFO RE installing the Windows Vista op-
erating system software (do not enable this option in Windows XP or on a Windows
Vista operating system that has been installed without the option enabled).
Intel Turbo Memory Technology (also known
as Robson flash memory) is an Intel
technology that reduces the time it takes for a computer to boot up, to load applica-
tions, and to write data to the hard drive. Intel Turbo Memory Technology is sup-
ported in Windows Vista only (it also supports Windows Vista features such as
ReadyBoost, ReadyDrive, and Superfetch).
Intel Turbo Memory & Matrix Storage Setup and Driver Installation
1. Start-up your computer and press F2 to enter the BIOS.
2. Go to the Advanced menu, select "Installed O/S" and make sure "Vista" is
the selected option (see “Advanced Menu” on page 5 - 8).
3. Go to the "SATA Mode Selection" item and make sure "AHCI" is selected.
4. Go to the "DFOROM (Robson) Support" item and make sure "Enabled" is
selected.
5. Go to the Boot menu (see “Boot Menu” on page 5 - 13).

e-SATA Port
Support
Note that the Intel Ma-
trix Storage driver is
required to enable the
e-SATA port even if you
have not included an In-
tel Turbo Memory mod-
ule in your purchase
configuration.
Follow the instructions
provided here in order to
install the driver.