Owner's manual

1 - 12 System Map: Left View

Quick Start Guide

System Map: Left View

4 6



Changing DVD Regional Codes

Go to the Control Panel and double-click Device

Manager (Hardware and Sound), then click the +

next to DVD/CD-ROM drives. Double-click on the

DVD-ROM device to bring up the Properties dia-

logue box, and select the DVD Region (tab) to bring

up the control panel to allow you to adjust the region-

al code (see “DVD Regional Codes” on page 2 -

5).

DVD region detection is device dependent, not OS-

dependent. You can select your module’s region

code 5 times. The fifth selection is permanent. This

cannot be altered even if you change your operating

system or you use the module in another computer.

Figure 1 - 5 - Left View

1. Security Lock Slot

2. Optical Device Drive Bay

(see page 2 - 3)

3. RJ-11 Modem Jack

4. S/PDIF-Out Jack

5. Microphone-In Jack

6. Headphone-Out Jack

7. Line-In Jack



CD Emergency Eject

If you need to manually eject a CD/DVD (e.g. due to an unex-

pected power interruption) you may push the end of a straight-

ened paper clip into the emergency eject hole. Do not use a

sharpened pencil or similar object that may break and become

lodged in the hole.

Media Warning

Don’t try to remove a floppy disk/CD/DVD while the system is

accessing it. This may cause the system to “crash”.