240-MC4 - User Manual

Installation and Operation Manual

Chilicon Power | Aug 2016

WARNING: Be aware that the body of the Chilicon Power Microinverter is the heat sink, and

although it usually rises less than 20°C above ambient, it can reach a temperature of 80°C. To

reduce risk of burns, do not touch the body of the microinverter.

WARNING: Do NOT attempt to repair the Chilicon Power Microinverter. If it fails, contact

customer support to obtain an RMA number and start the replacement process. Damaging or

opening the Chilicon Power Microinverter will void the warranty.

WARNING: Be aware that only qualified professionals should install and/or replace Chilicon

Power microinverters.

WARNING: Before installing or using a Chilicon Power Microinverter, please read all

instructions and warnings in the technical documents and on the Chilicon Power Microinverter

system itself as well as on the PV array.

WARNING: Be aware that installation of this equipment includes the risk of electric shock.

WARNING: Do not touch any live parts in the system, including the PV array, after the system

has been connected to the electrical grid.

WARNING: Do NOT connect microinverters to the utility grid or energize the AC circuit until you

have completed all of the installation procedures as described in the following sections.

WARNING: Do NOT remove AC or DC connectors to the invert under load. Doing so will not

damage the inverter, but the connectors are not rated for removal under load.

WARNING: Do NOT exceed the maximum number of microinverters in an AC branch circuit, as

displayed on the unit label (15 devices).

INVERTER LABEL INFOR MATION