AC Coupling with Microinverter Systems

September 1, 2016
[GRID INTERACTIVE ADVANCED FEATURES]
INSTALLING Z-WAVE HOME ENERGY METER
PAIRING THE HEM (HOME ENERGY METER)
The first step is to pair the HEM with the Gateway so that they can communicate with each other over the Z-Wave
wireless network. It is easier to pair HEM with the Gateway BEFORE installing them in the circuit box or disconnect
panels. This ensures there are in range of each other and that the wireless link is strong. Only Gen2 (DSB28-ZWUS)
and Gen5 (AEOZW095-US) Aeotec Home Meter Energy are currently supported by the Gateway but we highly
recommend to use the Gen5 version since it is more reliable and has better RF range.
From the home screen, press the Menu button . On the Settings screen, press “Advanced Settings” and then
“Measurement Setup” . The first step is to enable the Z-Wave communication hardware on the Gateway if that
has not been done yet. For that, make sure the box in front of “Enable Z-Wave communication” is checked (a dot
inside the box indicates it is checked). Below it will list the paired devices which at first will show that there are no
devices paired yet.