Datasheet

Installation Instructions WM2I
7
4. Lower the upper cover (A) onto the wall mount and
interactive cover (B), and fasten with two 8-32 x 3/8" Phillips
pan head screws (M) [or use two 8-32 x 3/8" security button
head screws (L)]. (See Figure 8)
NOTE: Be sure cables and cords are not pinched between
upper and lower covers.
Figure 8
5. Exit cables out bottom of cover and through cable
management clips. (See Figure 9)
Figure 9
Connecting Chief Interactive Mount
NOTE: Follow instructions in the Quick Start Guide (J).
IMPORTANT ! : After adding batteries to the stylus (C),
tighten the cap only to the point of being fingertip-tight.
Overtightening cap may cause the stylus to stop
transmitting signals.
1. Connect projector to computer
2. Connect USB cord (H) from cartridge in interactive cover (B)
to computer USB port.
3. Insert interactive software CD (F) into computer, and follow
start-up and operating instructions.
Minimum System Requirements for WM2XXSI
• Windows® System
• Compatible PC with Pentium™ II 400 MHz+
processor and 256 MB RAM
• Windows 2000, XP, Server 2003, Vista, or 7
• 30 MB available hard drive space
• Available USB port
• Macintosh® System
• Power PC®/Intel™ 1.42 GHz+ processor and 1G
RAM
• Mac OS X 10.5 through 10.6
• 25 MB available hard drive space
• Available USB port
Active Capture Area Size
• The maximum active capture area supported is:
4 ft x 7 ft or up to 94 inches diagonal measure.
• The minimum active capture area supported is:
1.7 ft x 1.1 ft.
Connection Requirement
• The interactive mount includes a USB cable.
Screen Recording Requirements
(Currently available only on Windows platform.)
• Pentium™ IV processor
• 1.4GHz, with 512MB RAM
4
(M or L) x 2
(A)
4
Cables
Cable management clips
(bottom view of mount)