Datasheet

Installation Instructions WM2I
5
ASSEMBLY AND INSTALLATION
The WM2I is designed to replace the existing cover(s) on the
WM210, WM220, WM230 and WM240, and to convert the
existing short throw mount to a Chief Interactive Mount
(WM2XXSI). The WM2XXSI works with standard projectors
and Windows® and Macintosh® computers. The Interactive
Mount will transform existing whiteboards or other hard, flat
surfaces, into interactive whiteboards and allows users to
present, annotate, and interact with their projected content and
all of their desktop applications.
Remove Existing Mount Cover(s)
NOTE: Proceed to appropriate section - Single Mount Cover
or Split Mount Covers.
• Single Mount Cover
1. Remove two Phillips pan head screws to release existing
mount cover. (See Figure 1)
Figure 1
2. Remove two hex bolts and bracket from the underside of
the mount. (See Figure 2)
Figure 2
3. Remove inner telescoping extrusion. (See Figure 2)
4. Slide mount cover away from wall mount and remove. (See
Figure 2)
5. Reinstall inner telescoping extrusion. (See Figure 3)
Figure 3
6. Reinstall bracket and fasten with two hex head bolts
removed in Step 2. (See Figure 3)
1
x 2
x 2
2
Bracket
2
4
3
Inner telescoping
extrusion
Mount cover
6
5
x 2
Bracket
6