INSTALLATION INSTRUCTIONS Telescoping Leg Interactive Whiteboard Mount Spanish Product Description German Product Description Portuguese Product Description Italian Product Description Dutch Product Description French Product Description WBM3E
WBM3E Installation Instructions DISCLAIMER Milestone AV Technologies and its affiliated corporations and subsidiaries (collectively "Milestone"), intend to make this manual accurate and complete. However, Milestone makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this product.
Installation Instructions WBM3E DIMENSIONS 46.93 1192.
WBM3E Installation Instructions LEGEND Tighten Fastener Pencil Mark Apretar elemento de fijación Marcar con lápiz Befestigungsteil festziehen Stiftmarkierung Apertar fixador Marcar com lápis Serrare il fissaggio Segno a matita Bevestiging vastdraaien Potloodmerkteken Serrez les fixations Marquage au crayon Loosen Fastener Drill Hole Aflojar elemento de fijación Perforar Befestigungsteil lösen Bohrloch Desapertar fixador Fazer furo Allentare il fissaggio Praticare un foro Bevestigin
Installation Instructions WBM3E TOOLS REQUIRED FOR INSTALLATION 7/16" 1/2" 1/8" - wood stud 1/4" - concrete, brick 5/32" (included) 1/2" PARTS B (4) [AF6 toggler] D (2) [Upright assembly] E (1) 5/32" A (4) 1/4" F (2) 1/4-20 x 3/8" G (4) [Isolation washer] C (4) 1/4-20 x 2-1/2" H (4) 1/4-20 x 1" J (4) .500x.320x.425 S (2) .4 x .255 x .
WBM3E Installation Instructions ASSEMBLY AND INSTALLATION Using Alternate Foot The WBM3E will allow an interactive whiteboard to be installed over an existing chalkboard or whiteboard. The WBM3E has telescoping legs which allows it to be anchored above and below the existing chalkboard or whiteboard, or anchored above the existing chalkboard or whiteboard with the lower extension resting against the existing board. 1. Place alternate foot (P) over bottom of upright assembly (D). (See Figure 2) 2.
Installation Instructions WBM3E Adjusting Wall Brackets for Installation NOTE: The wall brackets on the wall assembly may be adjusted to suit installation needs, but must be spaced a minimum of 16" apart. 1. Slide wall brackets along wall assembly (K). (See Figure 3) 2. Tighten button head cap screw on each wall bracket to secure wall brackets to wall assembly.
WBM3E 2. Installation Instructions Using a level, mark the wall above existing chalkboard through top mounting hole in the wall assembly (K). (See Figure 5) 4 8 (B) x 4 2 3 6 7 (D) x 2 Interactive white board (K) (J) x 4 1 2 5 9 (H) x 4 (A) x 4 (C) x 4 Figure 5 3. Drill one 1/4" x 2-3/4" pilot hole at each marking. (See Figure 5) 4. Install a toggler (B) into each pilot hole using a hammer. (See Figure 5) 5.
Installation Instructions WBM3E Adjustments 4. Adjust white board up or down, as required. (See Figure 10) Lateral Movement 5. Tighten four Phillips head screws (H) into four isolation washers (G) and spacers (J) to fasten white board to upright assemblies (D). (See Figure 10) 1. Loosen one button head cap screw at top of upright assembly (D). (See Figure 8) 2. Slide upright assembly left or right on wall assembly (K), as necessary. (See Figure 8) 3.
WBM3E Installation Instructions IMPORTANT ! : Complete WBM3E installation according to the type of installation selected: • • Concrete or Concrete Block Wall 1. Mark the wall through the adjustable leg (N) on each upright assembly (D). (See Figure 13) If the WBM3E has been installed with the alternate foot (P) attached, proceed to Adding Covers section to complete installation.
Installation Instructions 4. WBM3E Slide the sliding cover (M) down over the wall bracket cover (L) on both wall assembly brackets.
WBM3E Installation Instructions USA/International Europe Chief Manufacturing, a products division of Milestone AV Technologies 8800-002306 Rev00 2013 Milestone AV Technologies, a Duchossois Group Company www.chiefmfg.com 01/13 Asia Pacific A P F A P F A 6436 City West Parkway, Eden Prairie, MN 55344 800.582.6480 / 952.225.6000 877.894.6918 / 952.894.6918 Franklinstraat 14, 6003 DK Weert, Netherlands +31 (0) 495 580 852 +31 (0) 495 580 845 Office No.
