Installation instructions

2. Using four 10-24 button head cap screws, attach top and bottom to side brackets (see Figure 4 &
Figure 5). The square offset holes can be used if use of the center hole causes the cross brackets to
block connections or if an offset is needed for the installation (See Figure 6 & Figure 7).
3. Place Nylon spacers over mounting holes on back of screen. Attach mounting brackets to display
using M8 screws (see Figures 8 & Figure 9). If needed add both sets of spacers and use the set of
longer bolts to attain required clearance.
4. With the aid of another person, lift your display up to the Chief Mount, aligning buttons of mounting
brackets with slots in the Chief Mount.
5. Lower safety latch on the Chief Mount to secure your display, making sure latch is completely
engaged.
Figure 4 Figure 5
Figure 8
Figure 9
Figure 6 Figure 7