Datasheet

Installation Instructions Model: PPH-2000

ATTACH TILT ARMS TO STATIC BRACKET

1. Insert screw (180) through arm (60), washer (190),

bracket (20), washer (190), and arm (60). Install nut

(200). Using key (240), tighten only as required to

take up slack; overtightening will prevent arm (60)

from freely swinging on bracket (20) (See Figure 15).

NOTE: Washers (190) are nested between bracket (20)

and arm (60).

Figure 15: Attach Tilt Support Arm

2. Insert clevis pin (160) through arm (30), spacer (210),

bracket (20), spacer (210), and arm (30). Install cotter

pin (230) (See Figure 16).

NOTE: Spacers (210) are nested between bracket (20)

and arm (30).

Figure 16: Attach Lower Tilt Arm

3. Determine amount of tilt desired. Positive tilt arm

locking holes exist in arm (30) at 0° (no tilt), 5°, 10°,

and 15° (See Figure 17).

Figure 17: Tilt Arm Adjustment

4. Insert clevis pin (170) through arm (30) at desired

locking hole, washer (190), arm (60), washer (190),

and arm (30). Install cotter pin (220)(See Figure 18).

NOTE: Washers (190) are nested between arm (30) and

arm (60).

Figure 18: Attach Upper Tilt Arm

(60)

(200)

(20)

(190)

(180)

(160)

(30)

(160)

(210)

(20)

15°

10°

5°

0° (No Tilt)

(30)

(220)

(30)

(190)

(170)

(60)