Datasheet

Model: PPH-2000 Installation Instructions

ASSEMBLE TILT ARM

1. Using key (270), loosely install screws (80) through

latch (50) and spacers (70) into threaded holes in arm

(30) (See Figure 6). Ensure latch (50) is installed on

the upper end of arm (30).

Figure 6: Latch Assembly

2. Repeat for remaining arm (30).

3. Tighten screws (80) only as required to keep latches

(50) from freely slipping on arm (30). Latches are

designed to slide; do not overtighten screws (80).

4. Slide latch (50) to fully open (raised) position.

5. Using Phillips screwdriver, install screw (90) through

slotted hole in latch (50) into threaded hole in arm (30)

(See Figure 7). Tighten only as required to take up

slack; overtightening will close latch preventing

mounting button installation.

• If latch begins to close, loosen screw (90) and pull

latch (50) to open position.

Figure 7: Open Latch

ASSEMBLE SIDE SUPPORTS

1. Using key (260), loosely install support (40) to plate

(10) with screws (150) (See Figure 8). Ensure lip of

support (40) covers edge of plate (10).

2. Repeat for other 3 corners.

3. Once all screws (150) are installed, tighten securely.

Figure 8: Side Support Assembly

(50)

(80)

(70)

(30)

(4 Places)

Threaded

Hole in Arm

(4 Places)

(90)

Slotted Hole

Threaded Hole

in Latch (50)

Threaded Hole

in Arm (30)

in Latch (50)

(150)

(10)

(40)