Specifications

Installation Instructions PIWRF SERIES
9
CABLE MANAGEMENT
WARNING: IMPROPER INSTALLATION CAN LEAD TO
SERIOUS PERSONAL INJURY OR DAMAGE TO
EQUIPMENT! Make sure cables do not run through pinch
points.
1. Locate and install cable tie clips (J) where desired for proper
cable routing. (See Figure 12)
Figure 12
2. Route cables down arms on mount. (See Figure 13)
3. Position cable covers (L) over arm and cable and press
cable covers (L) down onto arms to secure cables. (See
Figure 13)
WARNING: IMPROPER INSTALLATION CAN LEAD TO
SERIOUS PERSONAL INJURY OR DAMAGE TO
EQUIPMENT! DO NOT route cables through holes in
faceplate.
Figure 13
ADJUSTMENTS
Pitch Tension Adjustment
To adjust display pitch tension:
1. With display installed, tighten or loosen two screws, one on
each side. (See Figure 14)
2. Check for desired tension.
3. Repeat Steps 1 and 2 until desired tension is obtained.
Figure 14
(J) x 8
1
(L) x 4
From Display
2
3
1