Specifications

PIWRF SERIES Installation Instructions

WARNING: ELECTRICAL SHOCK HAZARD! CUTTING

OR DRILLING INTO ELECTRICAL WIRES OR CABLES

CAN CAUSE DEATH OR SERIOUS PERSONAL INJURY!

ALWAYS make certain area behind mounting surfaces is free

of electrical wires and cables before cutting, drilling, or

installing fasteners.

WARNING: EXPLOSION AND FIRE HAZARD! CUTTING

OR DRILLING INTO GAS PLUMBING CAN CAUSE DEATH

OR SERIOUS PERSONAL INJURY! ALWAYS make certain

area behind mounting surfaces is free of gas, water, waste, or

any other plumbing before cutting, drilling, or installing

fasteners.

5. Cut drywall on outside edge of lines and remove.

6. Assemble upper and lower mounting rails (B) to mount (A)

in slots that correspond to the desired lateral shift offset

identified during Step 3 above using four flanged nuts (K)

assembled to mount (A). (See Figure 3) and (See Figure 4)

Figure 4

7. Install J-box(s) [not included] and route all in-wall cables

and wiring to mount enclosure keeping in mind the lateral

shift offset determined during Step 3 above. (See Figure 3)

WARNING: IMPROPER INSTALLATION CAN LEAD TO

MOUNT FALLING CAUSING SEVERE PERSONAL INJURY

OR DAMAGE TO EQUIPMENT! Wiring of equipment must

be performed by properly trained and certified persons

following all applicable codes.

8. Slide mount (A) enclosure into opening in wall.

(See Figure 5)

Figure 5

9. Place spacers (C) provided between wall and upper and

lower mounting rails (B) if required. (See Figure 6)

Figure 6

10. Secure mount to studs using four flat washers (F2) and four

lag screws (F1). (See Figure 7)

(B) x 2

(K) x 4

(A) x1

(A) x 1

(B) x 2