Specifications

Installation Instructions PIWRF SERIES
5
Installation
WARNING: IMPROPER INSTALLATION CAN RESULT IN
DEATH OR SERIOUS PERSONAL INJURY! This accessory
should be installed by qualified personnel only.
WARNING: IMPROPER INSTALLATION CAN LEAD TO
MOUNT FALLING CAUSING SEVERE PERSONAL INJURY
OR DAMAGE TO EQUIPMENT! DO NOT deviate from
installation instructions provided. DO NOT substitute
hardware.
The PIWRF Series is designed to accommodate up to 3-1/2" of
lateral shift adjustment (right or left display offset from center of
studs). This is accomplished by aligning the upper and lower
mounting studs on the housing with either the right hand or left
hand mounting holes in the upper and lower mounting brackets.
(See Figure 3)
IMPORTANT ! : Using the lateral shift feature will impact
the location of the Listed J-Box [not included] installation
on the housing. If housing lateral shift is used any Listed
J-box must be installed to the side opposite the direction
of adjustment.
1. Determine desired mounting location and locate studs using
a stud finder or similar method.
2. Accurately locate center of studs.
3. Determine desired lateral shift required. (See Figure 3)
4. Using a level mark housing opening location on wall using
the dimensions identified. (See Figure 2)
Figure 2
20.58"
Cutout Area
7.68
Figure 3
1
1
1
Upper Mounting Bracket
Lower Mounting Bracket
(Display Offset Left)
(Display Offset Right)
3-1/2"