Specifications

Installation Instructions PIWRF SERIES
11
Display Height Adjustment
The mount is designed to accommodate up to 1" of display
height adjustment.
To adjust display height:
1. With display installed, loosen adjustment locking screw
using hex wrench. (See Figure 17)
2. Adjust display height by turning adjustment nut in desired
direction. (See Figure 17)
3. Tighten adjustment locking screw when display is at desired
height. (See Figure 17)
Figure 17
YAW Tension Adjustment
The mount is designed to accommodate up to 40.3° of travel to
left and right of center.
To adjust YAW tension:
1. With display installed, loosen adjustment screw using hex
wrench. (See Figure 18)
2. Check for desired tension.
3. Repeat Steps 1 and 2 until desired tension is obtained.
NOTE: If changing from a smaller display to a larger display
may be necessary to increase tension.
Figure 18
3
2
1
3
1
TOP VIEW