Specifications

PIWRF SERIES Installation Instructions
10
Roll Adjustment
The mount allows for the horizontal alignment (Roll) of the
display to be adjusted up to 2° right or left to level the display
after installing.
To adjust Roll:
1. Loosen the roll tension adjustment nut located on the back
side of the faceplate assembly. (See Figure 15)
2. Level display.
NOTE: If display will not level slightly loosen top nut as well.
3. Tighten roll tension adjustment nut. (See Figure 15)
Figure 15
Extend/Retract Tension Adjustment
Arm Extend and Retract tension is pre-set at the factory and is
adjusted to accommodate displays with weights near the top of
the mount’s capacity.
If smaller displays are used it may be difficult to reposition the
display after mounting. Arm Extend and Retract tension can be
adjusted to compensate for smaller display by:
The display must be mounted prior to adjusting swing arm
tension.
1. With display installed, tighten or loosen adjustment screw
using hex wrench. (See Figure 16)
2. Check for desired tension.
3. Repeat Steps 1 and 2 until desired tension is obtained.
NOTE: If changing from a smaller display to a larger display it
may be necessary to increase tension.
Figure 16
2
1
3
2
(on back side
in this view)
1