INSTALLATION INSTRUCTIONS Instrucciones de instalación Installationsanleitung Instruções de Instalação Istruzioni di installazione Installatie-instructies Instructions d´installation J-Series Steel Stud Installation Kit Spanish Product Description German Product Description Portuguese Product Description Italian Product Description Dutch Product Description French Product Description MAC118
MAC118 Installation Instructions DISCLAIMER Milestone AV Technologies, Inc., and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this product.
Installation Instructions MAC118 TOOLS REQUIRED FOR INSTALLATION AND PARTS 1/2" (Ø13mm) (3/16") I/M A (1) x1 B (1) C (1) D (1) J (4) E (1) F (1) K (4) (1/4"-20) L (4) (1/4"-20 x 1 3/4") G (1) M (4) (1/4"-20 SNAPTOGGLE BB) TOG GLER Ă H (1) (1/4"-20) N (1) (3/16") 3
MAC118 Installation Instructions Site Requirements WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! The figure below identifies the minimum reguirements for installation of display mounts onto a steel stud structure. If the structure or its components do not meet these requirements contact the mount manufacturer for specific instructions before attempting installation.
Installation Instructions MAC118 Preparation of Existing Mount If mount has previously been installed: 1. 2. 3. Remove display from mount following instructions provided with mount. Remove mount from wall following instructions provided with mount. Proceed to step 4. If mount has not previously been installed: 4. Remove mount wall plate from swing arm assembly by removing screw, washers and spacers, pivot pin and locknut.
MAC118 Installation Instructions Mount Installation After determining the site meets the installation requirements: 1. 2. 3. Drywall Identify desired mounting location on wall. Using a stud finder or similar method locate studs. Align mounting holes in mount with studs making sure mounting holes are centered on studs. Plastic Straps WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! Make sure mounting holes are used on both sides! 4. 5.
Installation Instructions MAC118 Steel Stud Drywall Plastic Cap Plastic Straps Anchor Metal Channel SIDE VIEW Figure 7 11. Place mount over anchors and align mounting holes in display mount with holes in anchors. 12. Place flat washer (K) onto button head capscrew (L). 13. Insert Phillips pan head capscrews (L) with flat washer (K) through mounting hole in display mount and into anchor (M) and tighten until flush against mount.
MAC118 Installation Instructions USA/International Chief Manufacturing, a division of Milestone AV Technologies Europe Asia Pacific 8804-000344 RevD ©2008 Milestone AV Technologies www.chiefmfg.com 06/08 A P F A P F A 8401 Eagle Creek Parkway, Savage, MN 55378 800.582.6480 / 952.894.6280 877.894.6918 / 952.894.6918 Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands +31 (0)40 2668620 +31 (0)40 2668615 Room 24F, Block D, Lily YinDu International Building LuoGang, BuJi Town, Shenzhen, CHINA.
