Datasheet

KTC SERIES Installation Instructions
14
Display Pitch and Roll Adjustment
To adjust display pitch or roll position:
1. Loosen Centris bracket front adjustment knob. (See Figure
16)
2. Tilt display up or down, or adjust display roll left or right until
properly positioned.
3. Tighten Centris bracket front adjustment knob.
Figure 16
CABLE MANAGEMENT
The KTC Series mount includes cable management features
used to properly route and secure display cables.
To use the cable management features:
1. Connect cables to display.
2. Route cables through cable clips on array rail. (See Figure
17)
3. Route cables down pole and away from mount and secure
to pole using sheath (E). (See Figure 17)
Figure 17
4. Repeat steps 1-3 for additional array on KTC-330, 440 and
445.
Pitch/Roll
Adjustment
Knob
(E)
Cable Clips