Datasheet

Installation Instructions KTC SERIES
13
Figure 12
7. Slide display with Centris bracket onto array rail. (See
Figure 13)
NOTE: Repeat previous steps for each additional display.
8. Reinstall end locks into mounting rail using the 5/32" hex
key (J) (See Figure 14).
Figure 13
Figure 14
ADJUSTMENTS
Display Adjustment
The KTC Series mount allows horizontal, pitch, and rotational
adjustment of each display.
The KTC Series mount also allows a full 360 deg. of display
rotation with a maximum pitch range of 15° up and 15° down.
The 3/16" hex key included with the KTC-230 mount is to be
used to adjust the rotation on this model.
Display Horizontal Position Adjustment
To adjust display horizontal position:
1. Loosen Centris bracket rear adjustment knob (See Figure
15).
2. Slide Centris bracket with display left or right until properly
positioned on array rail.
3. Tighten Centris bracket rear adjustment knob.
Figure 15
Display
Centris Head
(S or T) x 4
(Q or R) x 4
6
4
Display with Centris Bracket
7
End Lock
End Lock Retaining Screw
Centris Head
Horizontal
Adjustment
Knob