Datasheet

KTC SERIES Installation Instructions
12
Figure 7
Figure 8
Figure 9
Attach Centris Head to Recessed Mount Display
NOTE: Refer to Table 1 to select the applicable screw and
spacer combination.
1. Uninstall end lock using the 5/32" hex key (J). (See Figure
10)
2. Slide Centris head off array rail. (See Figure 11)
Figure 10
Figure 11
3. Place display face down on a clean dry surface.
4. Place four 3/8" or 3/4" nylon spacers (S or T) over four
mounting holes in display back (See Figure 12).
5. Align Centris head mounting holes with four nylon spacers
(See Figure 12).
6. Secure Centris head to display using four M4 x 20mm
Phillips pan head screws (Q), or four M4 x 30mm Phillips
pan head screws (R). (See Figure 12).
Display
(P) x 2
1
Display
Centris head
2
Display
Centris Head
(P) x 2
3
Square Nut
End Lock
Centris Head
Centris Head
2