Datasheet

KTC SERIES Installation Instructions

INSTALLATION

Desk Clamp Installation

NOTE: In order to reduce the chance of scratching to the

mounting surface, bumpers may be installed. However,

installation of bumpers is optional.

1. Remove adhesive from underside of bumpers (H).

2. Attach bumpers (H) to underside of desk clamp (D). (See

Figure 1)

Figure 1

3. Use 7/32" hex key (J) to install 3/8-16 x 1" flat head cap

screw (W) through the opening on top of desk clamp (D) and

into bottom of mounting pole (F or G). (See Figure 1)

4. Determine the location where desk clamp will be mounted.

WARNING: Failure to keep all mounted equipment directly

above the desk surface at all times can result in serious

personal injury or damage to equipment! All mounted

equipment must remain directly above the surface of the

desk in order to ensure and maintain a stable mount.

5. Place desk clamp (D) over desired mounting location on

desk. (See Figure 2)

6. If there is not enough clearance behind the desk for the

device to clear, remove the bottom portion of the desk

clamp by using 5/32" hex key (L) to remove 2 connecting

screws. (See Figure 2)

7. Reinstall bottom portion of the desk clamp (if necessary) by

reinstalling 2 connecting screws underneath desk. (See

Figure 2)

Figure 2

8. Turn clamp screw until the clamp is secured to the desk as

tightly as possible. (See Figure 3)

Figure 3

(H) x 6

(W) x 1

(D)

(F or G)

(view from bottom)

(behind desk)