Installation instructions

K2C Series Installation Instructions
16
Pivot Adjustment Range
Single Arm Models
1. Adjust arm angle as desired up to 90 degrees in either
direction. (See Figure 23)
WARNING: Swinging the arm beyond 90 degrees may
result in the mount slipping off the desk causing serious
injury!
Figure 23
Dual Arm Models
1. Adjust arm angles as desired within a 90 degree range from
the edge of desk or wall and a perpendicular centerline of
mount. (See Figure 24)
WARNING: Swinging the arm beyond this range may result
in the mount slipping of the desk causing serious injury!
Figure 24
Swing Arm Pivot Adjustment
1. Adjust pivot position as desired. (See Figure 25)
2. Adjust pivot point tension screws to change pivot
adjustment tension. (See Figure 25)
Figure 25
Cable Management
Non-Array Models
1. Route cables through cable management channels. (See
Figure 26)
Figure 26
(top view)
+/- 90 degrees range
of motion
edge of desk or wall face
perpendicular centerline
90 degrees range
of motion per arm
edge of desk or wall face
(top view)
pivot point
tension
cable (typical)
1
1
1