Installation instructions

K2C Series Installation Instructions
14
For recessed mounting hole installation:
• Place four spacers (D) on top of mounting holes
on back of display. (See Figure 15)
• Using Phillips screwdriver, carefully install four
M4x25mm screws (C) through corresponding
holes on faceplate, spacers (D) and into the
mounting holes on the display. (See Figure 15)
Figure 15
4. Position display with faceplate attached above mount. (See
Figure 16)
5. Slide faceplate onto mounting head until quick release tab
clicks into place. (See Figure 16)
Figure 16
Handle Installation (K2C22 models only)
1. Loosen four screws securing handle brackets to K1C22H
array. (See Figure 17)
2. Install uprights of handle (J) into handle brackets located on
the back of K1C22 array. (See Figure 17)
Figure 17
3. Position handle (J) at desired height and secure by
tightening button head cap screws attaching handle
brackets to array. (See Figure 18)
Figure 18
(for recessed mounting holes)
(C) x 4
(D) x 4
quick release
faceplate
3
5
2
2
(J)
1
x 4
3
3
3
(J)
x 4