Installation instructions

K2C Series Installation Instructions
12
Display Installation (non-array versions)
NOTE: K2C22H models have K1 Series faceplates on array
arms. Proceed to K2C22H Models Section.
The mounting holes on the back of the display will either be
flush with the back surface or recessed into the back surface.
Refer to the applicable installation procedure.
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located between the K2C Series Monitor Arm
up to (and including) the display does not exceed the weight
limits listed below. Use with products heavier than the
maximum weight indicated may result in collapse of the
mount and its accessories causing possible injury.
Flush Mounting Holes
CAUTION: Using screws of improper size may damage
your display! Proper screws will easily and completely thread
into display mounting holes.
CAUTION: Inadequate thread engagement in display may
cause display to fall! Back out screws ONLY as necessary to
allow installation of Centris bracket!
1. Ensure faceplate is able to swivel and tilt easily, yet still be
tight enough to hold display in desired position. Adjust as
required before proceeding. See “ADJUSTMENT” for detail.
(See Figure 11)
2. Using Phillips screwdriver, carefully install two M4x14mm
screws (B) into the upper mounting holes on the display.
Thread screws completely into display, then back out 3
complete turns. (See Figure 11)
3. Pick up and align display so that screws (B) (installed on the
back of the display in the previous step) fit into the mounting
holes on the faceplate. Rotate the bracket as required.
Lower the display firmly into place. (See Figure 11)
Figure 11
4. Using Phillips screwdriver, install two remaining M4x14mm
Phillips screws (B) through the lower mounting holes in
faceplate into the display. (See Figure 11)
5. Tighten all four screws (B). Do not overtighten!
MODEL Max Weight
Allowed for EACH
Display
Max Weight
Capacity of
Mounting System
K2C110
22 lbs
(9.98 kg)
22 lbs
(9.98 kg)
K2C120
22 lbs
(9.98 kg)
22 lbs
(9.98 kg)
K2C220
22 lbs
(9.98 kg)
44 lbs
(19.96 kg)
K2C120SXF1
22 lbs
(9.98 kg)
22 lbs
(9.98 kg)
K2C220SXF1
22 lbs
(9.98 kg)
44 lbs
(19.96 kg)
K2C22H
9 lbs
(4.08 kg)
18 lbs
(8.16 kg)
K2C22HSXF1
9 lbs
(4.08 kg)
18 lbs
(8.16 kg)
2
4
3