Installation instructions

ManualsBrandsChief ManualsTVs & monitorsFSBVB

Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone

makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the

installation or use of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation

of warranty, expressed or implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the infor-

mation contained in this document.

Chief Manufacturing, a products division

of Milestone AV Technologies

8401 Eagle Creek Parkway, Savage, MN 55378

• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918

INSTALLATION INSTRUCTIONS

8804-000293 RevB

2009 Milestone AV Technologies,

a Duchossois Group Company

www.chiefmfg.com

10/09

BEFORE YOU BEGIN

Display Interface

Model: FSB-V

CAUTION: To prevent damage that could affect or void the Factory warranty, and to the equipment that will be

attached to it, thoroughly study all instructions and illustrations before you begin the installation.

• If you have any questions about this installation, contact Chief Manufacturing.

Summary of content (8 pages)

PAGE 1
INSTALLATION INSTRUCTIONS Display Interface Model: FSB-V BEFORE YOU BEGIN CAUTION: To prevent damage that could affect or void the Factory warranty, and to the equipment that will be attached to it, thoroughly study all instructions and illustrations before you begin the installation. • If you have any questions about this installation, contact Chief Manufacturing. Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
PAGE 2
Model: FSB-V Installation Instructions Table 1: Parts IMPORTANT WARNINGS AND CAUTIONS! ITEM WARNING: Failure to provide adequate structural strength for this component can result in serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the structure to which this component is attached can support five times the combined weight of all equipment. Reinforce the structure as required before installing the component.
PAGE 3
Installation Instructions Model: FSB-V INSTALLATION Back of Display CAUTION: IMPROPER INSTALLATION CAN LEAD TO DISPLAY FALLING! Use only hardware provided and referenced within these instructions. DO NOT substitute! Installation For Mounts Equipped With Latching Flags To install the FSB-V on Latching Flag Equipped Mounts: 1. Assemble four mounting buttons (20) to interface bracket (10) using four M4 x 12mm Phillips pan head screws (70).
PAGE 4
Model: FSB-V Installation Instructions Installation For Mounts Equipped With Centris Cup Technology Back of Display CAUTION: IMPROPER INSTALLATION CAN LEAD TO DISPLAY FALLING! Use only hardware provided and referenced within these instructions.
PAGE 5
Installation Instructions Model: FSB-V 7. Align two mounting screws (80) with upper teardrop mounting holes in Centris head. 8. Insert two upper mounting screws (80) into upper teardrop mounting holes in Centris head, and lower display until mounting screws are fully seated in lower area of teardrop mounting holes. (See Figure 8) NOTE: DO NOT fully tighten mounting screws at this time. Back of Display 80 80 Figure 9: Install Lower Mounting Screws 10. Fully tighten four mounting screws.
PAGE 6
Model: FSB-V 6 Installation Instructions
PAGE 7
Installation Instructions Model: FSB-V 7
PAGE 8
Model: FSB-V 8 Installation Instructions