INSTALLATION INSTRUCTIONS Instrucciones de instalación Installationsanleitung Instruções de Instalação Istruzioni di installazione Installatie-instructies Instructions d´installation Floor to Ceiling Cable Mount Spanish Product Description German Product Description Portuguese Product Description Italian Product Description Dutch Product Description French Product Description FCS1U
FCS1U Installation Instructions DISCLAIMER WARNING: Use this mounting system only for its intended Legrand | AV and its affiliated corporations and subsidiaries (collectively “Legrand | AV”), intend to make this manual accurate and complete. However, Legrand | AV makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this product.
Installation Instructions FCS1U DIMENSIONS 59.69 2.35 33.65 1.32 SLIDE LOCK HANDLE ATTACHMENT POINTS FOR PACFCB SECOND DISPLAY ACCESSORY 28.8 21.00 REFERENCE 457.20 18.00 A 14.00 5.03 14.00 24.55 FOR USE WITH PSBUB INCLUDED. SEE INSTALLATION MANUAL AND CUSTOMER PRINT FOR THE PSBUB DETAILS 25.40 1.
FCS1U Installation Instructions TOOLS REQUIRED FOR INSTALLATION 5/32" (3.97mm) - wood surfaces 1/4" (6.
Installation Instructions FCS1U PARTS - DISPLAY INTERFACE Hardware Kit MR (2) [Vertical bracket] Bag A Bag B Bag C MA (4) M4 x 12mm Bag D MB (4) M4 x 20mm Bag E MC (4) M4 x 25mm Bag F MD (4) M5 x 12mm Bag G ME (4) M5 x 20mm Bag H MH (4) M6 x 20mm MG (4) M6 x 12mm Bag J MMA (8) [Nesting spacer] MN (8) #10-24 x 1/2" Bag I MI (4) M6 x 25mm Bag L Bag K MJ (4) M8 x 12mm Bag M MF (4) M5 x 25mm MK (4) M8 x 20mm ML (4) M8 x 30mm MMB (4) [Universal spacer] MP (1) 1/8” MQ (2) [Horizontal brack
FCS1U Installation Instructions Assembly And Installation 3. Using claw portion of hammer, set each anchor (F) by pulling it out of hole approximately 1/4" (6.4mm). (See Figure 1) 4. Hang turnbuckle (G) or connecting link (C) through the hole on each concrete anchor (F).
Installation Instructions FCS1U Solid Concrete Floor WARNING: Anchors must be installed into structurally 3 sound solid concrete with a minimum thickness of 4" (101.6mm) or greater. Installation into hollow concrete block, mortar, or concrete that exhibits cracking, spalling, or other defects may result in failure of anchor and serious personal injury or damage to equipment! 1. Drill 1/4" diameter x 1-1/2" deep hole at each marked cable anchor support location (See Figure 3).
FCS1U 2. Installation Instructions Use four connecting links (C) and cable locks (D) to secure cables (J) to two outer frames (A). (See Figure 6) Display Installation NOTE: If connecting turnbuckles (G) behind display, connect WARNING: Exceeding the weight capacity can result in turnbuckles into top holes instead of connecting links (C).
Installation Instructions 8. FCS1U Select correct screws, nesting spacers (if necessary) and universal washers (if required) from the hardware bag (QAQM) and attach brackets to back of screen. (See Figure 10) IMPORTANT ! : The M8 screws do NOT require a washer. Use the universal washer (QMB) only with M4, M5 and M6 screws. NOTE: The nesting spacers (QMA) may be used separately, or put two together in different configurations to create different size spacers.
FCS1U Installation Instructions 11. Determine and mark the horizontal center position between the Left and Right TOP mounting holes in display. (See Figure 11) 12. Determine and mark the horizontal center position between the Left and Right BOTTOM mounting holes in display. (See Figure 11) 13. Orient upper horizontal mounting bracket (QQ) so that flanges are facing towards display and resting in recessed area of left and right vertical mounting brackets (QR). (See Figure 11) 14.
Installation Instructions FCS1U 18. Lift display onto mount, carefully placing mounting buttons into mounting locations on faceplate. (See Figure 13) 19. Slide locking plate over mounting buttons to secure display to mount. (See Figure 13) 18 18 19 Figure 13 20. Tighten two turnbuckles until cables are tight and mount is level. Adjustments Plumb Adjustment 1. Loosen lower screws holding brackets together. (See Figure 14) 2.
FCS1U Installation Instructions USA/International Europe 8800-003172 Rev00 2019 Legrand | AV www.legrandav.com 07/19 Asia Pacific A P F A P F A 6436 City West Parkway, Eden Prairie, MN 55344 800.582.6480 / 952.225.6000 877.894.6918 / 952.894.6918 Franklinstraat 14, 6003 DK Weert, Netherlands +31 (0) 495 580 852 +31 (0) 495 580 845 Office No.
