Installation instructions

ManualsBrandsChief Manualschassis componentsFCA623S

INSTALLATION INSTRUCTIONS

Instrucciones de instalación

Installationsanleitung

Instruções de Instalação

Istruzioni di installazione

Installatie-instructies

Instructions d´installation

XPAU/XVAU Dual Monitor Extension

Accessory

Spanish Product Description

German Product Description

Portuguese Product Description

Italian Product Description

Dutch Product Description

French Product Description

FCA623

Summary of content (12 pages)

PAGE 1
INSTALLATION INSTRUCTIONS Instrucciones de instalación Installationsanleitung Instruções de Instalação Istruzioni di installazione Installatie-instructies Instructions d´installation XPAU/XVAU Dual Monitor Extension Accessory Spanish Product Description German Product Description Portuguese Product Description Italian Product Description Dutch Product Description French Product Description FCA623
PAGE 2
FCA623 Installation Instructions DISCLAIMER damage to equipment! It is the installer’s responsibility to make sure the structure to which this component is attached can support five times the combined weight of all equipment. Reinforce the structure as required before installing the component. Milestone AV Technologies and its affiliated corporations and subsidiaries (collectively “Milestone”), intend to make this manual accurate and complete.
PAGE 3
Installation Instructions FCA623 LEGEND Tighten Fastener Pencil Mark Apretar elemento de fijación Marcar con lápiz Befestigungsteil festziehen Stiftmarkierung Apertar fixador Marcar com lápis Serrare il fissaggio Segno a matita Bevestiging vastdraaien Potloodmerkteken Serrez les fixations Marquage au crayon Loosen Fastener Drill Hole Aflojar elemento de fijación Perforar Befestigungsteil lösen Bohrloch Desapertar fixador Fazer furo Allentare il fissaggio Praticare un foro Bevestigi
PAGE 4
FCA623 Installation Instructions TOOLS REQUIRED FOR INSTALLATION #2 1/8” (included) 3/16” (included) 1/2” PARTS A (2) [Left upright] B (2) [Right upright] H (2) [Hardware bag B - quantities listed per bag] HA (4) HB (4) M6x12mm M6x16mm C (1) [Interface extension] HF (4) M8x12mm D (1) [Dual screen cover] E (3) #10-24 x 1 1/2” 4 F (1) 1/8” G (1) 3/16” HG (4) M8x16mm HC (4) M6x25mm HH (4) M8x25mm HD (4) 1/4” HE (4) 1/2” HI (2) 1/4-20 x 1 1/4”
PAGE 5
Installation Instructions FCA623 Assembly And Installation 4. The FCA623 is specifically designed to convert Chief’s XPAU or XVAU carts into 2x1 monitor mounting systems. Do not attempt to install the FCA623 onto any other mounting device! Remove four nuts holding interface head assembly to XPAU/XVAU column assembly to remove head assembly. (See Figure 3) NOTE: Installation procedure is identical regardless if installing to XPAU or XVAU. XPAU is shown in these instructions. 1.
PAGE 6
FCA623 Installation Instructions (rear view) 6 connecting brackets 9 (E x 3/removed screws x 3) front plate on top 8 removed nuts x 4 back plate tilt plate Figure 5 6. Slide two of four connecting brackets from XPAU/XVAU head assembly into corresponding groove on FCA623 interface. (See Figure 5) 7. Align four connecting brackets with outside four holes on tilt plate. (See Figure 5) 8. Use four nuts removed in Step 4 to secure tilt plate to new head assembly. (See Figure 5) 9.
PAGE 7
Installation Instructions FCA623 Display Installation 1. CAUTION: Using screws of improper length may damage Place display face down on a soft, non-abrasive surface. your display! Proper screws will have adequate thread engagement without contacting bottom of display mounting holes. NOTE: For best access, route display cables through columns prior to display installation. See Cable Management section for details. 4.
PAGE 8
FCA623 Installation Instructions WARNING: Exceeding the weight capacity can result in (below head assembly) serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the combined weight of each display and attached accessories does not exceed 300 lbs (137 kg) or 150 lbs (68.5 kg) per display after the FCA623 accessory has been installed to the XPAU or 250 lbs (113.4 kg) or 125 lbs (66.7 kg) per display if installed to the XVAU. 6.
PAGE 9
Installation Instructions FCA623 Adjustments Height Adjustment 1. Use upper knob on back of interface brackets (A and B) to adjust the height of each display. (See Figure 11) NOTE: Adjust both brackets in order to maintain a level mount. Plumb Adjustment 2.
PAGE 10
FCA623 10 Installation Instructions
PAGE 11
Installation Instructions FCA623 11
PAGE 12
FCA623 Installation Instructions USA/International Europe Chief, a products division of Milestone AV Technologies 8800-002521 Rev02 2014 Milestone AV Technologies www.chiefmfg.com 03/14 Asia Pacific A P F A P F A 6436 City West Parkway, Eden Prairie, MN 55344 800.582.6480 / 952.225.6000 877.894.6918 / 952.894.6918 Franklinstraat 14, 6003 DK Weert, Netherlands +31 (0) 495 580 852 +31 (0) 495 580 845 Office No.