Specifications

Installation Instructions DGI-42 and DGI-50
6
Attach Mount to Rear Panel
NOTE: Omit this procedure if the Rear Panel was
pre-installed at the factory.
1. Determine the exact mounting location prior to
installation and draw a level line to indicate the
desired height for the top of the Rear Exterior Mount
(A).
2. Place the Front Exterior Mount (B) over the eight
studs protruding through the Rear Panel (C).
3. Select mount orientation as follows:
a. For proper landscape orientation — the shoulder
screws on the Front Exterior Mount (B) should
be at the top, with the split panel on the Rear
Panel Assembly (C) on the bottom. See Figure 4.
b. For proper portrait orientation — the mounts
should be rotated 90 degrees (see Figure 5), with
consideration for the preferred swing direction of
the cover.
4. Torque the ¼-20 Nylock nuts to 70 in-lbs.
Figure 4. Attach Mount to Rear Panel
Pre
-
mounted
¼
-
20 studs
¼-20 Nylock nuts
Split panel
Shoulder
screws
Rear Interior Mount (D)
Rear Panel
Front Exterior
Mount (B)