Specifications

Installation Instructions DGI-42 and DGI-50
5
INSTALLATION
NOTE: Read the Warnings and Cautions on page 2.
Perform the following procedures to install the Display
Guard.
Wall Mount the Display Guard
To wall-mount the Display Guard, do the following:
1. Determine the exact mounting location prior to
installation and draw a level line to indicate the
desired height for the top of the Rear Exterior Mount
(A).
2. Ensure that the mounting position is at least the
minimum distance from the ceiling as noted in
“Table 1. Exterior Dimensions” on page 2.
WARNING: Improper installation can result in
serious personal injury! Make sure that
the structural framework can support a
weight factor five times the total weight
of the equipment as noted in Table 1 on
Page 2. If not, reinforce the structure
before installing the mount.
3. Check the Rear Exterior Mount (A) to ensure that it
is level and correct mounting to achieve level if
necessary. See Figure 3.
Figure 3. Rear View of Display Guard
IMPORTANT! For specific dimensions of rear
exterior mount refer to the customer print for the
enclosure being installed.
Orient Rear Exterior Mount (A)
with slots at the top