Specifications

Installation Instructions DGI-42 and DGI-50
11
Mount Display to Interior Mount
Mount the display to the interior mount as follows:
1. Mount display with installed Chief interface bracket
to Interior Mount Assembly (E) by inserting 4 slotted
bushings into keyhole slots (see Figure 12).
2. Seat properly, ensuring that all four bushing are
correctly engaged. Check clearances and display
centering and adjust interior mount location if
necessary.
NOTE: The location of the audio and display
connectors on the rear of your display may
require that you make the connections during
the final display mounting process.
Figure 12. Mount Display to Interior Mount
Rear of LFD
PSB
-
U Interface Bracket [NOT SHOWN]
[Interface bracket shown below for
illustration only]
Interior Mount Assembly (E)
Slotted bushing
(4 locations)
Slotted keyhole
(4 locations)