Datasheet

LTAPU Installation Instructions
4
PARTS
INSTALLATION
The LTAP has been designed to be mounted directly onto either
a 16 inch on center wood stud wall or concrete wall. The LTAP
has brackets which allow the TV to be tilted.
Locate Mounting Site
WARNING: IMPROPER INSTALLATION CAN LEAD TO
MOUNT FALLING CAUSING SEVERE PERSONAL INJURY
OR DAMAGE TO EQUIPMENT! It is the installers
responsibility to make certain the structure to which the
mount is being attached is capable of supporting five times
the weight of the LTAP not to exceed 200 lbs (90.7 kg).
WARNING: Proceed to either the Installing to a Wood
Stud Wall section or the Installing to a Concrete Wall
section.
Installing to a Wood Stud Wall
1. Determine the center of the TV screen, and where it should
be located on the wall.
2. Locate the closest stud to the left and right of the selected
location.
NOTE: If the screen area lies over a stud, use that stud and the
stud to either the left or right of it.
3. Line up the notches on mount with center of screen marking
to determine vertical center. (See Figure 1)
4. Measure up 6" from the center point to mark location of the
upper mounting slots.
Custom
LTAPXXX
Hardware
[Included only with
LTAPXXX Models]
G3 (6)
G5 (6)
A (1)
B (1)
G1 (8)
M4x16mm
G2 (6)
M4x20mm
M4x25mm
G4 (6)
M5x16mm
M5x20mm
G6 (6)
M5x25mm
G7 (6)
M6x16mm
G8 (6)
M6x25mm
G15 (1)
M5
G9 (6)
M8x20mm
G10 (6)
M8x30mm
G11 (4)
M8x50mm
G13 (8)
.750x.323x.250
G14 (8)
.750x.344x.500
G12 (8)
E1 (4)
5/16"
E3 (4)
5/16"
E2 (4)
5/16" x 2-1/2"
D (2)
G (1)
F (1)
F1 (8)
5/16"
F2 (8)
5/16" x 1/2"
F3 (1)
3/16"
[Wall Mount]
[Left Upright]
C (1)
[Right Upright]
[Universal
Washer]
[Display Bracket]
E (1)