Reamed Mouse User's Manual 1994-1998 Copyright All Rights Reserved FCC Statement on CLASS B Note: This equipment has been tested and found to comply with the limo ts for a CLASS B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful inter Terence when the equipment is operated in a residential installation.
Reamed (1) this device may not cause harmful interference. (2) this device must accept any interference received, including interference that may cause undesired operation. 1. Hardware Installation a Serial Mouse You must have a PC fitted with a serial in order to install the mouse. Plug your mouse into the serial port. 1-2. Installing a Mouse with Mouse Port (PS/2) Connector If you have a mouse with a round mouse port connector, you must tur n off the computer before connecting or disconnecting your mouse.
Mercado devices, such as keyboard, drawing devices, and printers. Generally , two devices connected to the same computer cannon use the same interrupt t. You must specify a mouse interrupt that does mot interfere with the oth er devices connected to your computer. The jumper refer to interrupts in the system (Iris. If you should change the jumper. Cross out the posit ions you cannot use due to the type or configuration of your system. The place the removable plastic hood on any position.
Reamed from the DOS prompt. Driver for Windows 3.1 & Windows NT 3.51 To install Mouse Driver for Windows 3.1( or NT 3.51 ), insert the floppy into the drive, click on File in Program Manager, select Run, and type if you insert the Mouse Driver Disk in drive A. or type if you insert the Mouse Driver Disk in drive B. Follow the instructions on the screen. 2-3 Mouse Driver for Windows 95 & Windows NT 4.0 To install Mouse Driver for Windows 4.
Reamed will nol remove the Mouse Driver in order to prevent your mouse f rom inactivation when you restart your computer again. But you can fo low the steps below to change the Mouse Driver latter before vou rest art your computer, (A) Windows 3.51 ): a) Double click on the "Windows Setup” icon in the Main Group b) Select "Options". c) Select "Change System Setting..." in Windows 3.1, Select "Change Mouse or Keyboard..." in Windows NT 3.51. dy Select e) Choose the new mouse driver you require.
Reamed the Mouse to emulate a three-buttoned Mouse Systems Mouse. 3-2. Switching Mouse Hardware Modes (None mode switch) As mentioned earlier, the serial mouse is capable of operating eighth er as a Microsoft Serial Mouse or a Mouse Systems Mouse. Which of the two modes the mouse will operate in is determined on the power-on initialization ion. If any one of the three buttons is depressed during power-on initial Ionization, the mouse will emulate Mouse Systems Mouse.
Solution Symptom 2 : moves Solution mine Symptom 3 nods Solution sting Symptom 4 : ent Solution Symptom 5 Solution Reamed Make sure the software that you are using supports a mouse. Check that mouse is plugged into serial port at the back of computer. Ensure that mouse driver is installed into memory. The cursor on the screen remains at one spot oF erratically. © Check the mouse cable for any breaks or sharp twists. Fxa the cable closely where it connects to the mouse.
