User's Manual

7
4-1.Moving problems
4-1-1.First please avoid to the following places for the proper installation.
1) The direct rays of the sun
2) Hot, cold, dusty, moisture or unstable places
3) Under the magnetic force.
4) Near fax machine, TV sets, radio, cellular phones and other RF products
5) On metal board
4-1-2.Check the following notes for moving precisely.
1) Install the driver properly
2) Examine the distance between receiver and transmitter
3) Check the power source of the battery in transmitter and the receiver is
plugged in computer properly
4) Select a suitable channel
4-1-3.Too much interfere
1) Change the location of receiver
2) Put the unit at a certain distance from high voltage and other electronic
equipments.
4-1-4.Wheel operating problems
1) Verify that the "Browser Mouse" or "Mouse Control Panel" application is
installed properly. If you do not find the "Browser Mouse" or "Mouse
Control Panel" icon in the system tray, you need to reinstall mouse software.
2) Some other applications with mouse scrolling function may conflict with this mouse function.
Remove these applications before install this mouse software.
4-2.Cursor trouble
4-2-1.If the cursor on the screen remains at one spot or moves erratically, check the mouse cable for
any breaks or sharp twists and examine the cable closely where it connects to the mouse.
4-2-2. When the cursor movement stops at a corner and no longer responds to the mouse movement,
please run the mouse driver to check which mode the mouse is operating in.
4-2-3.While mouse movement does not produce corresponding cursor movement or there is a brief
pause during movement, try to clean the silicon rubber-coated ball and rollers.
5-2.Installation problems
5-2-1.Detection problems with PS/2 Pointing Devices
If your mouse is connected to the mouse port and is not detected by the system, attempt the
following step(s):
1)Your mouse port might need to be enabled through the SETUP menu of your computer. Please
check your computer documentation regarding the SETUP menu.