User's Manual

Mouse software supports DOS, Windows 3.1, Windows 95, Windows 98,

Windows NT 3.51, Windows NT 4.0, Windows 2000 and Windows ME.

Before installing any software under Windows NT 4.0, we

strongly recommend you create an Emergency Repair Disk using

the Repair Disk utility provided by the system (RDISK.EXE).

Please note that USB mice are only supported under Windows 98

, Windows 2000 and Windows ME.

2-1. Mouse Driver for DOS

Run Dosinst.bat to install the DOS mouse software.

* DOS Driver Options

The DOS mouse driver has several software options. To see

these detailed options on the screen by typing :

mouse /?

2-2. Mouse Driver for Windows 3.1

Run Setup3x.exe to install the Windows 3.1 Mouse software.

2-3. Standard Installation for Windows 95, Windows 98,

Windows NT 4.0, Windows 2000,and Windows ME.

Run Setup.exe to install the Mouse software.

2-4. Drivers Only Installation

You can load device drivers without running the Setup program.

Loading the device drivers this way, however, the Setup program

will be loaded automatically after the drivers installed.

Please execute the following steps to perform a drivers-only

installation for Windows 2000: