User's Manual

1. Hardware Installation

1-1.Installing a Mouse with Mouse Port (PS/2) Connector

If you have a mouse with a round mouse port connector, you must turn off

the computer before connecting or disconnecting your mouse.

1-2.Installing a USB Mouse

When you use a mouse with USB connector , you don’ t have to shut off the computer. Just plug the

USB connector into the USB port

1-3.Installing a Combo (USB→PS/2)Mouse

The Combo Mouse comes with a USB connector, together with

a USB→PS/2 port adapter. Before plug your mouse into the computer, try to make sure what kind of

mouse port you have. If you have a USB port, plug in the original USB connector; if you have a

PS/2 port, please connect the adapter first to the cable, then plug into the PS/2 port.

1-4.Select a Suitable Channel and ID

1-4-1.First, check how many channels of the mouse on the package or the channel

switch. Choose and switch 1 or 2 channel on the back of mouse and charger (receiver). There

will be some interfere when your nearby classmates or colleagues and you are using the same

channel. Change to the other channel immediately when it happened. If your mouse is only

one-channel type, just skip this section.

1-4-2. Press the ID defining button on the back of charger, then press the ID defining button on the

back of the mouse. The RF Wireless Optical Mouse will choose the best ID automatically after

selecting a suitable channel and pressing the ID defining buttons. There are several changeable

ID for each channel.

1-5.Battery Suggestion

1-5-1. Recommend battery: Two AAA Ni-MH rechargeable batteries for mouse. For first time using,

put the mouse on the charger for charging over 8 hours at least. While charging, the red LED on

the charger will flash unsteadily. When the power is enough, the indicator will be light steadily.

Finished charge and pull out the mouse from the charger, then indicator will be disappear. The

green LED on the charger will flash unsteadily, while moving the mouse or changing the ID way.

Otherwise, the indicator will be light steadily..

1-5-2.Mouse will be on sleep mode, while non-used after 90~100 seconds. Press any button to use

mouse again. When the mouse is almost out of power, the indicator on the rubber wheel will be

light while moving the mouse. Please change the batteries or put the mouse on the charger.

2. Mouse Driver Installation