User's Manual

3
4)ID four: Press wheel button first, then ID defining button. Release ID defining button first, then wheel
button.
1-5-3.After you select ID and send signal from mouse, the mouse receiver
will receive and automatically detect and correspond to mouse for the
working linkage. After you successfully finish ID setting, the LED
indicator of receiver is corresponding to every move of the working mouse
by confirming of lighting flash.
If you want to re-define the ID, you have to press ID setting button on
the back of receiver firstly. Then, select one of the other mouse ID
setting ways. When you saw the confirming of lighting flash again, you
successfully finished the working linkage.
*Note: once you change the batteries, don't forget to re-define the ID as well.
2. Mouse Driver Installation
Mouse software supports DOS, Windows 3.1, Windows 95, Windows 98,
Windows NT 3.51, Windows NT 4.0, Windows 2000 and Windows ME.
Before installing any software under Windows NT 4.0, we
strongly recommend you create an Emergency Repair Disk using
the Repair Disk utility provided by the system (RDISK.EXE).
Please note that USB mice are only supported under Windows 98
, Windows 2000 and Windows ME.
2-1. Mouse Driver for DOS
Run Dosinst.bat to install the DOS mouse software.
* DOS Driver Options
The DOS mouse driver has several software options. To see
these detailed options on the screen by typing :
mouse /?