User's Manual

Instructions

FCC Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with a minimum distance of 0.5

centimeters between the radiator and your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.

The antennas used for this transmitter must be installed to provide a separation distance of at least

0.5 cm from all persons and must not be co-located or operating in conjunction with any other

antenna or transmitter.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause

undesired operation.

 Frequency: 2400~2483.5MHz  Maximal power: 6.47dBm

 CE declaration info: www.chiayo.com.tw/declaration.html

Battery installation & indicator

When the transmitter is switched

ON, the battery power LED (red)

will blink once to denote the

batteries installed are in good

condition

If the LED remains illuminated the

batteries have expired and require

replacement.

This transmitter requires 2 x AA

batteries to operate.

To install, open the battery cover

using the cover release buttons

and insert the batteries into the

battery compartment.

IMPORTANT: Batteries contain a corrosive acid that may leak and

damage the transmitter when stored for a long period. Batteries should be

removed from the transmitter before storing without use for more than 4

weeks.