PAK&RAK ATTENTION: BEFORE REMOVING THIS FIREARM FROM ITS PACKAGE READ & UNDERSTAND WARNINGS, INSTRUCTIONS AND PRECAUTIONS IN THIS USER’S MANUAL OFFICIAL SPONSOR PAK&RAK instruction manual – JANUARY 2018 Pag.
WARNINGS………………………………………………………………………………………………………....3 SAFETY RULES………………………………………………………………………………………………………4 IDENTIFYING MARKINGS……………………………………………………………………………………..5 AMMUNITION……………………………………………………………………………………………………..6 PAK & RAK DESCRIPTION……………………………………………………………………………………………………………………………..8 HANDGUARD’S ADJUSTMENTS………………………………………………………………………………………………..10 SIGHT’S ADJUSTMENTS…………………………………………………………….…………………………………..…………11 LOADING………………………………………………………………………………………………………………………………….
WARNINGS The manufacturer is not responsible for damages to objects caused by misuse of the gun or for injuries to persons or animals, or in case of death, caused voluntarily or involuntarily by the gun user. The manufacturer is not responsible for injuries caused by poor maintenance, misuse of the gun, unauthorized or improper modifications.
SAFETY RULES 1. Read the instructions carefully before use. Reading the manual and careful examination of the gun are fundamental to avoid any kind of problem. 2. Be aware that you are handling a firearm; therefore your knowledge and behaviour may affect your life and those of the people close to you. 3. Guns and ammunitions must be kept in separate places. 4. ALWAYS keep guns and ammunitions out of reach of children. 5.
24. When selecting a place to shoot, always be absolutely sure of your target and the area behind it before you touch the trigger, making sure there is an adequate backstop which will stop and contain bullets. A bullet can travel through or past your target with a range up to 1 1/2 miles. If you have any doubt, do not shoot. 25. Never shoot against a solid surface or in a pool of water, the projectiles could ricochet and shoot toward any direction. Don’t shoot up into the sky. 26.
AMMUNITION NOTICE WE SPECIFICALLY DISCLAIM RESPONSIBILITY FOR ANY DAMAGE OR INJURY WHATSOEVER OCCURRING IN CONNECTION WITH, OR AS THE RESULT OF, THE USE OF FAULTY, OR NONSTANDARD, OR “REMANUFACTURED” OR HANDLOADED (RELOADED) AMMUNITION, OR OF CARTRIDGES OTHER THAN THOSE FOR WHICH THE FIREARM WAS ORIGINALLY CHAMBERED. Death, serious injury, and damage can result from the use of wrong ammunition, bore obstructions, powder overloads, or incorrect cartridge components.
Bullets can become lodged in the barrel: If the cartridge has been improperly loaded without propellant powder, or if the powder fails to ignite. Ignition of the cartridge primer alone will push the bullet out of the cartridge case, but usually does not generate sufficient energy to expel the bullet completely from the barrel. If the bullet is not properly seated tightly in the cartridge case.
RAK 9 OR RAK22 DESCRIPTION This NEW rifle is chambered in .22 LR and 9 mm. It’s developed by our company, based on the AK platform. Our “design” recreates the original one, but works with two economical and modern calibers (.22 LR or 9 mm). These guns are semi-automatic rifles with a recoil operated system. Designed as a extension of the very famous AK 47 assault rifle, the rifle preserves all the original AK shapes.
PAK DESCRIPTION This pistol is a 9mm caliber chambered model, developed by our company, based on the generous AK platform. It is a short barreled version, semi-automatic, recoil operated system weapon. Designed as a caliber extension in 9mm of the very famous AK 47 assault rifle, the pistol preserves as much of the AK shapes. All the modifications imposed by the new operating system and the new caliber, were made by modifying, as little as possible, the original shape.
BREAK-IN PERIOD Before firing the pistol for the first time, field strip and clean the firearm following the proper procedures. For a proper break-in of the firearm shoot 200-300 rounds of high-velocity, quality factory ammunition, cleaning and lubricating the gun every 150-200 rounds ATTENTION: For best performance of the RAK 22 LR we recommend the use of quality .22 LR ammunition with a minimum velocity of 335 m/s ( 1100 f/s) Please allow 100-150 rounds for initial “Break-In” period.
FRONT SIGHT’S ADJUSTMENTS for PAK and RAK AIMING AT A TARGET This is the correct alignment: the front sight should be seen exactly in the middle of the rear sight slit, and have the same height. The top line of the sights should be leveled with the bottom of the aim. FRONT SIGHT’S ADJUSTMENTS The PAK and RAK’s front sight is adjustable in elevation and windage. NOTE: to adjust your front sight, the use of appropriate tool is required 1.
2. To adjust your impact’s point to the “RIGHT”, shift the “windage sight” to the left; to adjust your point of impact to the “LEFT”, shift the “windage sight ” to the right. REAR SIGHT’S ADJUSTMENTS for PAK The Pak rear sight is adjustable as follows; 1. Unscrew and remove the “rear sight’s screw” 2. Move the rear sight in the desired position 3. Screw “Pak’s handguard screw” PAK&RAK instruction manual – JANUARY 2018 Pag.
REAR SIGHT’S ADJUSTMENTS for RAK The rear sight is adjustable in elevation: 1. Push the rear sight’s button; 2. While keeping pushed the button, shift the slide forward to raise your impact’s point or shift backwards to lower your impact’s point UP LOADING WARNING: Keep muzzle pointed in a safe direction and follow all safety procedures any time. Practice these steps with an unloaded gun or dummy ammo until you are completely familiar and comfortable with the procedures.
2. PAK9 and RAK9 To release the magazine, push the magazine’s button. 3. RAK 22 To remove the magazine, push the magazine’s button. While keeping pushed the button, rotate anti-clockwise and pull out the magazine to remove it PAK&RAK instruction manual – JANUARY 2018 Pag.
4. To load the magazine, place the round at the top (open end), push down and backwards making sure that the back of the cartridge is facing the rear of the magazine. Repeat this procedure until magazine is fully loaded (10 rounds). Tap the back side of the magazine against the palm of your hand to insure the proper alignment of the cartridges 5. For RAK 22: Place the magazine in the rifle: rotate clockwise and pull up the magazine to engage it.
SHOOTING/FIRING Always wear eye and hearing protection when shooting. 1. 2. 3. 4. Point muzzle in a safe direction. Load rifle as previously directed. Grip the frame firmly. Place index finger on trigger, take aim and gently squeeze rearward until hammer is released and falls forward striking the firing pin. Be prepared for loud noise and recoil. Note: This is a semi-automatic rifle and will cock the hammer each time the bolt moves to the rear, ejecting the empty cartridge and chambering a new round.
5. Release the bolt so to have a gun in a safety position Remember to always unload the magazines: they should NEVER be left loaded for any length of time. DISASSEMBLY AND ASSEMBLY for PAK and RAK Clean the gun after every use and when exposed to dirt, sand, etc. When not in use, store in a clean dry location. 1. With the rifle unloaded, the magazine removed and the hammer down, push the cover’s button PUSH 2. While keeping pushed the cover’s button, open the cover 3.
PUSH Note: handle with care and hold firmly the recoil spring assembly during this operation. The recoil spring is tensioned, it can expand and can cause injury. 4. Take out the buffer 5. Pull rear the bolt in order to remove it PAK&RAK instruction manual – JANUARY 2018 Pag.
7. FOR PAK a. push the hand guard’s button b. While keeping pushed the handguard’s button turn anticlockwise the handguard to remove it from gun Note: This stage of disassembly is sufficient for you to clean the rifle or study the wear of the parts. To replace worn/broken parts of the firing mechanism, the front or rear sights or the firing pin and extractor, we suggest to take your rifle to an authorized gunsmith.
CLEANING Attention: Careful and detailed cleaning of this firearm is essential to guarantee its safety and proper function. This product should be cleaned after every use and when exposed to dirt, sand, etc. When not in use, clean at least twice for year. A careful and scrupulous ordinary clearing of the firearms is essential to guarantee its safety and long life. We recommend to clean the weapon at least after shooting 200/300 shots.
LUBRICATION With the rifle disassembled, use a quality gun oil (grease is not recommended). If oil contains Teflon be sure to shake well before using, because the Teflon settles at the bottom when is not used for a lot time. Lubricate the following internal parts of the pistol: a. bolt and Frame rails (do not over oil) b. Hammer and trigger - Small drop. c. Barrel mouth. d. Behind and beneath the bolt. Assemble the rifle, operate the bolt 5-6 times, and wipe off excess oil from gun.
people near you. Always pay great attention and handle the gun very carefully, in order to avoid terrible accidents which may change your life and that of others. WARRANTY CONDITIONS The manufacturer guarantees that our products are scrupulously checked against defects in materials, workmanship and aesthetical and functioning problems. In case you find a defect in one of our products, you should immediately contact the DEALER/SHOP/GUNSMITH where you have bought your gun.
THE GUARANTEE IS VOID IN CASE: Inadequate ammunition has been used (any ammunition but those commonly on sale, reloaded ammunition, different from caliber and specification indicated on the firearm barrel.
Request form REPAIR UNDER GUARANTEE RMA : _____________________ Please write in the above box the Repair Number you were given by the gun shop 1. Customer data: Name: ______________________________________ Address : ____________________________________ Town : ______________________________________ ZIP Code : ___________________________________ Phone : _______________Available from ____ to ____ Fax : _____________________ Email address: ________________________________ 2.
Note PAK&RAK instruction manual – JANUARY 2018 Pag.
PAK&RAK instruction manual – JANUARY 2018 Pag.
1415 Stanley Avenue Dayton, Oh 45404 USA Via Milano 2 25010 Azzano Mella (BS) ITALY www.chiappafirearms.com email: info@chiappafirearms.com PAK&RAK instruction manual – JANUARY 2018 Pag.
