AUGUST 2011 INSTRUCTION MANUAL M6 ATTENTION: BEFORE REMOVING THIS FIREARM FROM ITS PACKAGE READ & UNDERSTAND WARNINGS, INSTRUCTIONS AND PRECAUTIONS IN THIS USER’S MANUAL OFFICIAL SPONSOR
INDEX WARNING ........................................................................................................................................................ 3 SAFETY RULES .................................................................................................................................................. 5 IDENTIFYING MARKINGS .................................................................................................................................. 6 MODEL RANGE ...............
WARNING WHEN PULLING DOWN ON THE LEVER TO OPEN THE BARRELS, THE HAMMERS ARE BEING COCKED AND THE FIRING PINS ARE RETRACTED INSIDE THE FRAME. DO NOT PULL THE TRIGGERS WHEN THE BARRELS ARE OPEN. THIS WILL CAUSE THE FIRING PINS TO STAY EXTENDED OUT FROM THE BREECH’S FACE AND WHEN CLOSING THE BARRELS CAN CAUSE THE FIREARM TO SLAM FIRE AND/OR DAMAGE THE FIRING PINS. ALWAYS CHECK WHEN CLOSING THE BARRELS THAT THE FIRING PINS ARE NOT EXTENDED OUT OF THE BREECH’S FACE.
The manufacturer is not responsible for damage to objects caused by misuse of the gun or for injuries to persons or animals, or in case of death, caused voluntarily or involuntarily by the gun user. The manufacturer is not responsible for injuries caused by poor maintenance, misuse of the gun, unauthorized or improper modifications.
SAFETY RULES 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. 22. Read the instructions carefully before use. Reading the manual and careful examination of the gun are fundamental to avoid any kind of problem. Be aware that you are handling a firearm; therefore your knowledge and behaviour may affect your life and those of the people close to you. Guns and ammunitions must be kept in separate places. ALWAYS keep guns and ammunitions out of reach of children.
23. NEVER run with a loaded gun, don’t cross any obstacle (fences or water courses, etc.) or walk where there is any possibility of slipping or falling without having your firearm unloaded and in safety position. 24. When selecting a place to shoot, always be absolutely sure of your target and the area behind it before you touch the trigger, making sure there is an adequate backstop which will stop and contain bullets. A bullet can travel through or past your target with a range up to 1 1/2 miles.
WITH SET OF INSERTS CODE CF500.184 CF500.186 CF500.182 CF500.187 Barrel length DESCRIPTION CALIBER in cm 47 CHIAPPA M6 12ga/22lr 18,5" WITH INSERTS 12/22LR 18,5 47 CHIAPPA M6 20ga/22lr 18,5" WITH INSERTS 20/22lr 18,5 47 CHIAPPA M6 12ga/22 mag.18,5" WITH INSERTS 12/22mag 18,5 47 CHIAPPA M6 20ga/22mag.
If the bullet is not properly seated tightly in the cartridge case. When such a cartridge is extracted from the chamber without being fired, the bullet may be left behind in the bore at the point where the rifling begins. Subsequent chambering of another cartridge may push the first bullet further into the bore. If there is any reason to suspect that a bullet is obstructing the barrel, immediately unload the firearm and look through the bore. It is not sufficient to merely look in the chamber.
WINDAGE KNOB SIGHT ADJUSTMENT The front sight is a fixed fiber optic sight. The rear sight is adjustable in height and windage. Setting of the rear sight The elevation is adjusted by moving the leaf up and down. There are 4 possible positions, each defined by a click. The windage is adjusted by turning the windage knob (part # 33 from exploded view). Mounting an optical sight To mount an optical sight, the standard sight can be removed by loosening the nuts on the base of the sight.
SHOOTING/FIRING Always wear eye and hearing protection when shooting. 1. Point muzzle in a safe direction. 2. Load gun as previously directed. 3. Grip the frame firmly. 4. (Disengage the safety). 5. Place index finger on trigger, take aim and fully pull the trigger rearward. NOTE: the front trigger will fire the upper barrel; the rear trigger will fire the lower barrel.
Instruction Manual – M6, rev. MAY 2019 Pag.
REF 1 1 2 3 4 5 6 7 7 8 9 10 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 24 25 26 27 28 28 CODE 750.237 750.240 700.164 731.092 103.015 731.094 770.621 740.480 740.483 731.088 731.097 770.618 770.625 740.478 130.111 731.095 740.479 721.188 740.481 790.237 721.190 790.235 721.189 790.236 770.623 770.622 770.619 770.624 750.147 100.010 731.099 731.098 731.100 DESCRIPTION X-CALIBER polypropylene stock Polypropylene stock, M6, X-Caliber Receiver Swivel belt screw Cylindr.
M6 EXPLODED VIEW Instruction Manual – M6, rev. MAY 2019 Pag.
WARRANTY CONDITIONS The manufacturer guarantees that our products are scrupulously checked against defects in materials, workmanship and aesthetical and functioning problems. In case you find a defect in one of our products, you should immediately contact the DEALER/SHOP/GUNSMITH where you have bought your gun. The seller will indicate the conditions for the repair, which will be either made directly by them or through our assistance.
THE GUARANTEE IS VOID IN CASE: Inadequate ammunition has been used (any ammunition but those commonly on sale, reloaded ammunition, different from caliber and specification indicated on the firearm barrel) The firearm failed to be provided proper maintenance and cleaning The firearm has been modified without our prior consent Unauthorized, inadequate or incorrect repairs have been carried out Non original spare parts were used Parts subject to wear and corrosion Damage (improper use of the
Request form REPAIR UNDER GUARANTEE NDR : _____________________ Please write in the above box the Repair Authorization Number 1. Customer data: Name: ______________________________________ Address : ____________________________________ Town : ______________________________________ ZIP Code : ___________________________________ Phone : _______________Available from ____ to ____ Fax : _____________________ Email address: ________________________________ 2.
Instruction Manual – M6, rev. MAY 2019 Pag.
