Instruction Manual

Instruction Manual FAS 611 Pg. 6
LOADING THE RIFLE
WHEN LOADING KEEP ALWAYS THE RIFLE MUZZLE POINTED IN A SAFE DIRECTION!
Before shooting check if the AIR CYLINDER, with air pressure meter, is filled. Holding the gun
securely with your left hand grasp the lever handle firmly and toward the rear of the gun.
The lever will remain open when it reaches the full rear position (Fig.4), the trigger mechanism will be
engaged.
The proper caliber pellet can be inserted into the pellet channel (Fig.5). Beware of its proper orientation.
Push the loading lever forward and at the end of the stroke you can feel higher resistance. Overcome
this resistance to push lever to the receiver. The pellet is loaded in the barrel and striking mechanism is
cocked and gun is ready to shoot.
CAUTION: The gun has no trigger safety. Therefore do not insert your finger in the trigger guard in
course of cocking and loading.
Fig.3 Fig.4 Fig.5
UNLOADING THE PELLET
Fire the pellet at a safe target to unload the airgun. If this is not practical, open the barrel and push the
pellet from the chamber by running a cleaning rod through the muzzle end. Insert a felt cleaning pellet
and discharge into a safe target.
NEVER LEAVE THE GUN UNATTENDED!
ADJUSTMENT OF REAR SIGHT
To adjust your point of impact to the “RIGHT”,
tighten (clockwise) the windage sight screw on the
left side of the rear sight
To adjust your point of impact to the “LEFT”,
loosen (counterclockwise) the windage sight screw
on the left side of the rear sight
To adjust your point of impact “UP”, loosen
(counterclockwise) the elevation sight screw on top
of the rear sight
To adjust your point of impact “DOWN”, tighten
(clockwise) the elevation sight screw on top of the
rear sight
Fig.6