AUGUST 2011 INSTRUCTION MANUAL FAS 611 Official Sponsor OFFICIAL SPONSOR
INDEX FAS 611 .................................................................................................................................................................. 3 WARNINGS .......................................................................................................................................................... 3 IDENTIFYING MARKINGS ..............................................................................................................................
FAS 611 FAS 611 is a PCP (pre-charged pneumatic) air rifle is designed for wide range of users, mainly by the sport shooters. Design of the air rifle complies with ISSF rules and (for Great Britain also AMTA conditions). FAS AR611 is ready to shoot caliber .177”/4,5 mm (muzzle energy 7.5J or 16J) or .22”/5,5 (muzzle energy 40J). Technical data Caliber Muzzle energy (J) Weight (Kg/lbs) Stock length (mm/in) Barrel length (mm/in) Stock Trigger Barrel 4,5 (.177), 5,5 (.22) 7,5 / 16 / 40 3,65/7.8 700/27.
SAFETY RULES Not a toy, adult supervision required. Dangerous up to 100 meters. 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. Always handle your air gun as if it were loaded. Never point your air gun at anything you do not intend to shoot. Keep the air gun in a safe place out of reach from children. Store ammunitions separately. Before putting down the air gun always make sure that it is not loaded. Never abuse your air gun by using it for any purpose other than shooting.
AIR CYLINDER FILLING USE ONLY CLEAN, FILTERED AND DRY COMPRESSED AIR! For filling the compressed AIR CYLINDER use only compressed-air bottle, compressor or mechanical pump complying with your country’s requirements for use with such devices and limited to 230 bar operation. DO NOT ATTEMPT TO EXCEED THE 200 BAR AIR PRESSURE! The AIR CYLINDER can be damaged irreversibly and thus the gun in whole. For filling the AIR CYLINDER you can find in package an adapter (Fig.2).
LOADING THE RIFLE WHEN LOADING KEEP ALWAYS THE RIFLE MUZZLE POINTED IN A SAFE DIRECTION! Before shooting check if the AIR CYLINDER, with air pressure meter, is filled. Holding the gun securely with your left hand grasp the lever handle firmly and toward the rear of the gun. The lever will remain open when it reaches the full rear position (Fig.4), the trigger mechanism will be engaged. The proper caliber pellet can be inserted into the pellet channel (Fig.5). Beware of its proper orientation.
AIMING AT A TARGET This is the correct alignment: the front sight should be seen exactly in the middle of the rear sight slit, and have the same height. The top line of the sights should be level with the bottom of the aim. Fig.
THE BARREL ADJUSTMENT FAS AR611 offers the opportunity to rotate with the barrel to get correct point of the impact on target. - Loosen the two socket head screws situated in the front part of the receiver (Fig.9) - Rotating the barrel to the sides is possible change a direction of the hits. - Tighten the two screws before you shoot. DON’T PULL OUT THE BARREL FROM THE RECEIVER! Fig.
CLEANING AND MAINTENANCE Cleaning the rifle is recommended - After getting wet - In the mild weather conditions at least once a year - In the severe weather conditions at least once per month, depending on frequency of use Cleaning the bore and pellet chamber For ultimate accuracy clean and re-lube the barrel frequently. Correct materials for this purpose are very important; therefore use only products recommended by air rifle specialists in relevant countries.
Disassembly for cleaning ALWAYS KEEP THE RIFLE MUZZLE POINTED IN A SAFE DIRECTION! The FAS AR611 air rifles are based on a modular concept, consisting from sub-assemblies shown at Fig.13. Fig.13 To dismantle the rifle in the mentioned subassemblies follow this procedure: The Barrel-action disassembly - Unscrew by hand the compressed-air AIR CYLINDER. - Using Allen key, loosen the two bottom screws (Fig.14). - Open loading lever toward the rear of the gun.
WARRANTY CONDITIONS The manufacturer guarantees that our products are scrupulously checked for defects in materials, workmanship and aesthetic and functional problems. In case you find a defect in one of our products, you should immediately contact the DEALER/SHOP/GUNSMITH where you purchased your gun. The seller will indicate the conditions for the repair, which will be either made directly by them or through our assistance.
In case, for any valid reason, you do not have the possibility to obtain repair under guarantee at the shop where you bought the air gun, you may contact us directly; we will indicate a local dealer to support you with the repair file: USA - Phone: +1-937-835-5000 e-mail: info@chiappafirearms.com CANADA (Murray Charlton) – Phone +1-778.426.3884 e-mail: murray.mdcent@gmail.com REST OF THE WORLD - Phone: +39/030/9749065 e-mail: info@chiappafirearms.
PARTS LIST NR CODE PART NAME QTY NR CODE PART NAME QTY 1 2 731.142 770.662 OTTURATORE FAS 611 LEVA ARMAMENTO FAS 611 Bolt FAS 611 Cocking lever FAS 611 1 1 50 51 130.115 180.021 RULLINO 3X35.8 MOLLE A TAZZA 16X8X1.2 Ruller 3x35.8 Disk springs 16x8x1.2 1 12 3 770.661 BIELLA FAS 611 Connecting rod FAS 611 1 52 731.150 ATTACCO BOMBOLA FAS 611 Air cylinder connection 1 4 731.144 MASSA BATTENTE FAS 611 Hammer FAS 611 1 53 160.049 OR2010 2.57X1.78 Oring 2.57x1.78 1 5 731.
EXPLODED VIEW Instruction Manual FAS 611 Pg.
Via Milano 2 25020 Azzano Mella (BS) - Italy Chiappa Firearms USA, LTD 1415 Stanley Avenue Dayton, OH 45404 www.chiappafirearms.com email: info@chiappafirearms.com Instruction Manual FAS 611 Pg.
