User's Manual

The Main Menu
WAP Service
108
Configuring WAP profiles
You can configure up to 5 sets of WAP settings. Each set of WAP settings is
called a WAP profile. The WAP profile may have already been programmed
on your SI M card after you subscribe the WAP service to your system so you
can access mobile Internet immediately. Otherwise, you need to configure the
settings manually. Please contact your system operator for details.
Setting up a WAP profile
1. I n standby mode, press the left soft key.
2. Scroll to
WAP service and press Select.
3. Scroll to
Profiles and press Select.
4. Scroll to an empty profile and press
Select.
5. Scroll to
Edit and press Select.
6. According to the parameters supplied by your operator, configure the fol-
lowing:
H omepage: Enter the address of the homepage.
Session mode: Temporary or Permanent.
Connection security: On or Off.
D ata bearer: GSM data or GPRS. If GSM is selected, you need to setup
the
D ial-up number, D ata call type and D ata call speed. I f
Before setting up a WAP profile, please be sure to obtain the following parameters from your
operator:
H omepage:
Session mode: Temporary Permanent
Connection security: On Off
D ata bearer: GSM Data (Dial-up number, Data call type, Data call speed)
GPRS (GPRS access point )
IP address: . . .
Authentication type: Normal Secure
U sername:
Password:
Informat ion you need in case you have to set up a WAP profile manually