Technical data

Vehicle care 275
Set the compressor near the tyre
in such a way that the sealant
bottle is upright.
JE81A
8. Unscrew valve cap from
defective tyre.
9. Screw the filler hose to the tyre
valve.
JE82A
10. Set the rocker switch on the
compressor to I. The tyre is filled
with sealant.
11. The compressor pressure gauge
briefly indicates up to 6 bar whilst
the sealant bottle is emptying
(approx. 30 seconds). Then the
pressure starts to drop.
12. All of the sealant is pumped into
the tyre. Then the tyre is inflated.
JE83A
13. The prescribed tyre pressure
(approx. 2.4 bar) should be
obtained within 10 minutes.
When the correct pressure is
obtained, switch off the
compressor.
If the prescribed tyre pressure is
not obtained within 10 minutes,
remove the tyre repair kit. Move
the vehicle one tyre rotation.